Equipment & Preparation To assemble the Gambler’s Chest Box Insert, you will need: Each tray is delivered as one or more wooden punch out boards. The rear of the boards will have burn marks from the cutting process, that optionally can be removed with sandpaper, this is optional, and has not been done on the pictures […]
Category Archives: Assembly Instructions
Equipment & Preparation To assemble the Aeon Trespass: Odyssey Insert, you will need: Each tray is delivered as one or more wooden punch out sheets. Some sheets have parts from multiple trays on them, these are denoted by an engraved line splitting the sheet and each section being labelled. In the image below, you can […]
Equipment and Preparation To assemble the trays you will need: Wood glue/PVA, ideally quick drying with a fine nozzle on the bottle. Paper towel, for cleaning up excess glue. Piece of card, or something to protect your work surface. You will get glue on it! Scissors (felt lined versions), for trimming felt strips to length. […]
The large abominations box is relatively similar to the standard slide in trays, however miniatures slide in to all sides of the tray. The image above shows the layout of the pieces for the abominations box. Note the five different types of rails and their relative locations (click for bigger image) Use the regular sliding […]
These instructions cover gripper trays from multiple inserts. The exact number of grippers and layer may vary depending on which game you are building an insert for. Equipment and Preparation To assemble the trays you will need: Wood glue/PVA, ideally quick drying with a fine nozzle on the bottle. Paper towel, for cleaning up excess […]
Equipment and Preparation To assemble the trays you will need: Wood glue/PVA, ideally quick drying with a fine nozzle on the bottle. Paper towel, for cleaning up excess glue. Piece of card, or something to protect your work surface. You will get glue on it! Sandpaper (optional), for cleaning up burn marks on boxes. The […]
Felt Lining If not felt lining your insert, you can skip this step. The trebuchet tray uses one of the spare long strips labelled “Abominations”. Cut a strip of felt out of the Abominations sheet, by cutting at each end. Run a thin line of glue around the inside of slots on the trebuchet holder […]
Introduction In this set of instruction we are going to cover how to assembly the Miniature Display Stand. Equipment and Preparation To assemble the display stand you will need: Clear 2-part epoxy resin glue, ideally quick drying. For ours we used Gorilla Clear Epoxy Cocktail sticks for stirring and applying glue. Scrap plastic tray for […]
Equipment and Preparation To assemble the Kingdom Death Monster Box Insert, you will need: Wood glue, ideally quick drying with a fine nozzle on the bottle. Paper towel, for cleaning up excess glue. Old card/newspaper, to protect your work surface from glue. Elastic bands (optional), for holding tray together whilst glue dries. Sandpaper (optional), for […]
Introduction In this set of instruction we are going to cover how to assembly the Miniature Display Shelves. In the pictures we are going to show an equivalent MDF version of shelves made with wood glue, rather than the clear acrylic shelves with epoxy resin. The only reason for this is to make the work […]
- 1
- 2